High Bay PIR Occupancy Switches

High Bay Narrow

Narrow detection:
HB PIR ND
HBA PIR ND

High Bay Spot

Spot detection:
HB PIR SP
HBA PIR SP

High Bay Wide

Wide detection:
HB PIR WD
HBA PIR WD

 

EasyZAPP

HB Installation Guide

HBA Installation Guide

High Bay PIR occupancy switches

This range of HIGH BAY passive infra-red (PIR) occupancy switches is specifically designed for the automatic control of lighting loads in areas with demanding mounting heights such as factories, storage aisles, entrance halls and sports halls. They include a relay with special high surge contact material, so they are suitable for use with high bay LED lamps.
The products incorporate a passive infra-red quad sensor to detect movement of a warm body within its detection zone and a photocell to monitor the ambient light level. All standard high bay controls are hard wired and can be mounted directly onto solid ceilings or onto a range of different mounting boxes.
Each control is hard wired and can be mounted directly onto solid ceilings or a range of different mounting boxes.

 

HB PIR ND, HB PIR SP and HB PIR WD (Presence detection)

These controls operate by Presence Detection. The PIR switch will automatically switch the lights ON when a person enters the room. It will automatically switch the load OFF or to its reduced lux level (minimum) when no further movement is detected for its RUN-ON time.

 

HBA PIR ND, HBA PIR SP and HBA PIR WD (Absence detection - momentary switch required)

These controls operate by Absence Detection. It requires a retractive (momentary) switch to be pressed when a person enters the room. This will switch the lights ON and enable the PIR switch to control the load. The load will automatically be switched OFF or to its reduced lux level (minimum) when no further movement is detected for its RUN-ON time.

Specification

Detection zone: 360°
Time lag range:

0, 1, 2, 5, 10, 15, 20, 30 mins and infinite (always ON at minimum)

Minimum load: 2W resistive, suitable for most energy saving lamps, LED’s and emergency fittings.
Photocell range: 30 to 1000 lux, and inactive
Loading: Up to 6 amps (1500W) of resistive loads.
Up to 6 amps (1500W) of fluorescent loads.
Up to 3 amps (750W) of electronic and wire wound transformer loads.
Up to 2 amps (500W) of CFL, 2D lamps, LED Drivers and LED lamps and fittings.
Up to 1 amp (250W) of fans.
Dimensions: 90mm diameter x 63mm