EasyZAPP

EasyZAPP

Download Installation Guide

Download User Guide

Download App

Download Installation Guide

Programmable Energy Saving Control for switching and dimming DALI ballasts

This remotely programmable control can be mounted directly onto solid ceilings or a range of different mounting boxes. Programmable by Android phone (4.3 or later) or tablet via Bluetooth Smart. Easy to configure interface enabling greater energy saving, safety and security.
EZ CESR DALI is designed for use with DALI ballasts (broadcast).
It also includes a relay with special high surge contact material, so they are suitable for use with high bay LED lamps.
Complete with DALI Power Supply Unit suitable for controlling up to 20 DALI ballasts.

Product code: EZ CESR DALI

App suitable for Android devices 4.3 or later.

 

Specification

Voltage Suitable for mains voltage 100 - 260Vac, 50Hz (switch mode).
Loading:

Suitable for switching and dimming DALI ballasts (broadcast only) and can control up to 40mA, eg. 20 ballasts at 2mA (varies according to make and model of ballasts).
DANLERS DALI Power Supply Unit is rated at 40mA (DALI standard allows 250mA maximum). The controls interface of a DALI ballast normally sources at 2mA. Please refer to your ballast instructions.

They can also switch up to:

  • 10 amps (3000W) of resistive loads
  • 6 amps (1500W) fluorescent lamps, high frequency or switch start, incandescent or mains halogen lamps (recommended with integral safety fuse)
  • 3 amps (750W) of electronic or wire wound transformers.
  • 2 amps (500W) of: CFL, LED drivers and LED lamps and fittings.
  • 1 amp (250W) of fans or most metal halide lamps.
Detection range: 360 degrees with 8m diameter when mounted at a 2.4m ceiling height.
Time Lag: Can be easily adjusted by APP to individual requirement from 10 seconds to 23 hours 59 minutes 59 seconds
Lux: Enabled: 30 to 1000 lux and infinite lux (photocell inactive).
Dimensions: Device: 91mm diameter x 45mm
Power Supply: 120 x 50 x 32mm

 

Additional Features

  • Password protection
  • Batch programming
  • Up to 100m signal range
  • ON / OFF override
  • Easy to install
  • Ideal for retrofit or new build

 

  • DimensionsOpen or Close
    Dimensions: 91 x 91 x 45 mm dimensions
  • Detection DiagramsOpen or Close

    icn-detection-strongStrong detection zone
    ie. person moving arm

    icn-detection-secondarySecondary detection zone
    ie. person walking (less sensitive when walking straight towards PIR switch)

    For optimum coverage recommended mounting height between 2.4 and 5m.

    PIR Quad detector gives 124 detection areas within the zone

    cesr-detection-diagram-1

    Perspective view of detection zone

    For optimum coverage recommended mounting height between 2.4 and 5m

    cesr-detection-diagram-2
  • Wiring DiagramsOpen or Close
    Single EZ CESR DALI Wiring Diagram - Single