Home Products Literature Trade price list Contact details
Radio remote control functions
These products are used for the remote control switching or dimming of lighting or other loads. The wire-free senders are available as hand held or wall mounted versions. A receiver switch or receiver dimmer is wired into the existing circuit to control the connected load. The sender signals can pass through walls, so the receivers can be mounted out of sight, if desired. Inside a typical building the receivers can work at an approximate range of 30-50 metres. In free air the range is approximately 100-150 metres.
For the simplest set-up of all, one receiver can be controlled by one sender. Any receiver can be programmed to respond to the unique coded signal from any sender button. Hence, if desired, a sender button can control any number of receivers simultaneously. Also a receiver can be controlled by up to 15
sender buttons.		 These control combinations can in turn be mixed and matched, making it possible to have almost any control set-up desired, from the simplest single room to an entire building.
Senders
Brick walls:
approx.
60-90%
penetration		 Timber
framework
with sandwich
plasterboards:
approx. 80-95%
penetration		 Reinforced
concrete:
approx.
20-60%
penetration		 Metal walls:
approx.
0-10%
penetration		 Conventional
glass: approx.
70-90%
insulating glass
(with vaporised
metal coat):
approx. 30-60%
penetration		 Plastics:
approx.
80-95%
penetration
Typical signal ranges:
Approximately 30-50m inside a building;
Approximately 100-150m in free air.
The radio signals cannot pass through the entire length of
walls. The radio signals achieve a range of approximately
30-50m inside a building; 100-150m in free air.
e-mail: sales@danlers.co.uk Phone: +44 (0)1249 443377 Fax: +44 (0)1249 443388