|
|
|
WAPIR(PIR occupancy switches) |
|
|
Wall mounted PIR switch, no neutral required.
The WAPIR model replaces an existing wall switch – no neutral wire is needed. It fits into a plaster depth (16mm) wall box. The WAPIR model also has a manual override off switch on the front of the plate.
The WAPIR requires a permanent live supply, and should only be used in applications where the lights would not be on for more than 12 hours per day. This is to allow its rechargeable battery enough time to recharge itself from the mains supply.
The WAPIR is suitable for small offices, meeting rooms, tutoring rooms, etc.
The override off button enables the lights to be held off during video presentations, etc. For wall mounting only. |
|
|
|
| Specification |
| Detection zone: |
120º |
| Time lag range: |
10 seconds to 40 minutes in 9 steps |
| Photocell range: |
100 to 1000 lux, and inactive |
| Maximum loading: |
up to 6 amps (1500W) of resistive, fluorescent or inductive lighting loads, or up to 1 amp (250W)
of fans |
| Minimum loading: |
40W resistive or 100W inductive, or approximately 100W inductive per WAPIR in the circuit. Load capacitors (order code CAPLOAD) can be supplied to augment small loads |
| Dimensions (mm): |
86 x 86 x 22 |
| Wall box depth (mm): |
16 |
|
| Detection diagrams |
|
|
|
|
Wiring diagrams |
| Single WAPIR |
|
 |
|
|
|
A few WAPIR
wired in parallel |
|
 |
|
|
|
| Dimensions (in mm) |
|
|
| e-mail: sales@danlers.co.uk |
Phone: +44 (0)1249 443377 |
Fax: +44 (0)1249 443388 |
|
