Batten mounted 'Intelligent' photocell switch

bmintph

Download Installation Guide

Batten mounted 'Intelligent' photocell switch

DANLERS Batten Mount Photocell switch can be mounted onto the end of lighting battens via the 20mm knock out. The switch includes the connection 20mm thread and 1 metre of wire tails to connect to the lighting ballast.

This product will, when set up and calibrated, inhibit the artificial lights from switching on if the measured lux (on the working plane) is greater than the user set threshold. If the artificial lights are ON and the LUX then rises greater than the set threshold (plus the “stored calibrated hysteresis” – saved during calibration) the product will then switch the artificial lights off after a preset time delay.

This technology has a GB patent pending No: 1219746.3.

The calibration process removes the site specific addition of artificial light from any decision to switch the lights on/off.

Product code: BMINTPH

 

 

Ideal for use in factories, warehouses, offices, schools, hospitals etc.
Cost effective, easy to fit. IP53 rated enclosure.

 

 

Specification

Weatherproof: IP53 rating
Time lag: 1 minute to 60 minutes (adjustable)
Photocell range: 10 lux to 1000 lux (adjustable)
Loading: Up to 10 amps (2500W) of resistive loads.
Up to 6 amps (1500W) of fluorescent loads.
Up to 3 amps (750W) of electronic and wire wound transformer loads.
Up to 2 amps (500W) of CFL, 2D lamps, LED Drivers and LED lamps and fittings.
Dimensions: 120 x 50 x 36mm plus 1 metre wire tails